Ram 1500/2500/3500: Stop/Start System - If Equipped
Ram Truck 1500 2500 3500 (2009 - 2018) Owner's Manual / Starting And Operating / Stop/Start System - If Equipped
The Stop/Start function is developed to save fuel and reduce emissions. The system will stop the engine automatically during a vehicle stop if the required conditions are met. Releasing the brake pedal will automatically re-start the vehicle.
READ NEXT:
Automatic Mode
The Stop/Start feature is enabled after every normal
customer engine start. It will remain in STOP/START
NOT READY until you drive forward with a vehicle
speed greater than 5 mph (8 km/h). At that tim
To Start The Engine While In Autostop Mode
While in DRIVE the engine will start when the brake
pedal is released or the throttle pedal is depressed. The
transmission will automatically reengage upon engine restart. During this
transition the
To Manually Turn Off The Stop Start System
1. Press the STOP/START Off switch (located on the
switch bank). The light on the switch will illuminate.
STOP/START OFF Switch
2. The STOP/START OFF message will appear in Electronic
Vehicle Informa
SEE MORE:
Adding Fuel
The fuel filler cap (gas cap) is located behind the fuel
filler door, on the left side of the vehicle. Open the fuel
door and remove the fuel cap by turning it counterclockwise.
Fuel Filler Cap
NOTE: When removing the fuel filler cap, lay the cap
tether in the hook, located on the fuel filler door.
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand - held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink button you wish to
program.
3. Simultaneously press and hold both the HomeLink
button you want to
© 2020-2026 Copyright www.ram-manuals.com
