Ram 1500/2500/3500: Operation
Pushing the Trailer Mode button once, while at Normal Ride Height (NRH) will lower the vehicle to trailer level.
NOTE: The LED will continuously blink until vehicle trailer level that been achieved.
Pushing the Trailer Mode again will raise the vehicle to Normal Ride Height (NRH).
NOTE: The LED will continuously blink until Normal Ride Height (NRH) has been achieved.
- Transport Mode - No indicator lamps will be illuminated.
Transport Mode is disabled by driving the vehicle.
- Tire/Jack Mode - The LED will be illuminated. Tire/ Jack Mode is disabled by driving the vehicle.
- Wheel Alignment Mode - The LED will be illuminated.
Wheel Alignment Mode is disabled by driving the vehicle.
READ NEXT:
Axle Locker System - Power Wagon Models Only (If Equipped)
This vehicle is equipped with electronically locking front
and rear differentials. These differentials, when engaged,
mechanically lock together the axle shafts forcing the
wheels to spin at an equal
Stabilizer/Sway Bar System - Power Wagon Only
Your vehicle is equipped with an electronic disconnecting
stabilizer/sway bar. This system allows greater front
suspension travel in off-road situations.
Due to the use of taller springs, this vehicl
SEE MORE:
Off-Road Driving Tips
Care should be taken when attempting to climb steep
hills or driving diagonally across a hill or slope. If natural
obstacles force you to travel diagonally up or down a hill,
choose a mild angle and keep as little side tilt as possible.
Keep the vehicle moving and make turns slowly and
cautiously.
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand - held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink button you wish to
program.
3. Simultaneously press and hold both the HomeLink
button you want to
© 2020-2026 Copyright www.ram-manuals.com
