Ram 1500/2500/3500 Owners & Service Manuals

Ram 1500/2500/3500: Power Inverter - If Equipped

A 115 Volt (150 Watts Maximum) outlet is located on the center stack of the instrument panel, to the right of the radio. This outlet can power cellular phones, electronics and other low power devices requiring power up to 150 Watts. Certain high-end video games, such as Playstation3 and XBox360 will exceed this power limit, as will most power tools.

The power inverter is designed with built-in overload protection. If the power rating of 150 Watts is exceeded, the power inverter will automatically shut down. Once the electrical device has been removed from the outlet the inverter should automatically reset.

Power Inverter - If Equipped
Power Inverter Outlet

To turn on the power outlet, simply plug in the device.

The outlet automatically turns off when the device is unplugged.

NOTE: Due to built-in overload protection, the power inverter will shut down if the power rating is exceeded.

WARNING!

To avoid serious injury or death:

  • Do not insert any objects into the receptacles.
  • Do not touch with wet hands.
  • Close the lid when not in use.
  • If this outlet is mishandled, it may cause an electric shock and failure.

    READ NEXT:

     Cupholders

    Front Seat Cupholders (40-20-40 Seats) The cupholders are located on the backside of the center portion of the front seat (20). Fold down the center section of the front seat to gain access to the cup

     Storage

     Glove Compartment

    The glove compartment is located on the passenger side of the instrument panel and features both an upper and lower storage area. Glove Compartment Upper Glove Compartment Lower Glove Compartment

    SEE MORE:

     Hill Start Assist (HSA) - If Equipped

    The HSA system is designed to assist the driver in launching a vehicle on an incline. HSA will maintain the level of brake pressure the driver inputs for a short duration once the driver takes his foot off of the brake pedal. If the driver does not apply the throttle during this short duration, the

     Programming A Non-Rolling Code

    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand - held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink button you wish to program. 3. Simultaneously press and hold both the HomeLink button you want to

    © 2020-2025 Copyright www.ram-manuals.com