Ram 1500/2500/3500: Remote Keyless Entry (RKE)
The RKE system allows you to lock or unlock all doors, tailgate, and the RamBox (if equipped) as well as activate the Panic Alarm from distances up to approximately 66 ft (20 m) using a hand-held radio transmitter with integrated key. The transmitter does not need to be pointed at the vehicle to activate the system. Press and release the LOCK button on the RKE transmitter to lock all doors, the tailgate and the RamBox (if equipped).
The turn signal lights will flash and the horn will chirp to acknowledge the signal.
NOTE: Inserting the Key Fob with RKE transmitter into the ignition switch disables the system from responding to any button presses from that RKE transmitter. Driving at speeds 5 mph (8 km/h) and above disables the system from responding to all RKE transmitter buttons for all RKE transmitters.
Key Fob With Remote Keyless Entry (RKE) Transmitter
(IGNM)
Key Fob With RKE Transmitter Keyless Enter-N-Go
Fob (KIN)
READ NEXT:
Remote Unlock The Doors
Push and release the UNLOCK button on the RKE
transmitter once to unlock the driver's door. Push the
unlock button twice within five seconds to unlock all
doors, the tailgate and the RamBox (if equipp
To Lock The Doors
Push and release the LOCK button on the RKE transmitter
to lock all doors, the tailgate and the RamBox (if
equipped). The turn signal lights will flash and the horn
will chirp to acknowledge the signa
Transmitter Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
Perchlorate Material - special handling may apply.
Do not touch the battery terminals that are on the back
housing or the printed c
SEE MORE:
Hard-Keys
Hard-Keys are located below the Uconnect system in
the center of the instrument panel. In addition, there is a
Scroll/Enter control knob located on the right side of the
Climate Controls in the center of the instrument panel.
Turn the control knob to scroll through menus and
change settings (i.e.,
Before You Begin Programming HomeLink
Ensure your vehicle is parked outside of the garage
before you begin programming.
For efficient programming and accurate transmission of
the radio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the
device that is being programmed to the HomeLink
syst
