Ram 1500/2500/3500: Slide-In Campers
Camper Applications
Certain truck models are not recommended for slide-in campers. To determine if your vehicle is excluded, please refer to the "Consumer Information Truck-Camper Loading" document available from your authorized dealer.
For safety reasons, follow all instructions in this important document.
NOTE: When a cap or pickup camper is installed on a vehicle, an alternate Center High-Mounted Stop Light (CHMSL) must be provided.
READ NEXT:
Easy-Off Tailgate
To simplify mounting of a camper unit with an overhang,
the tailgate can be removed.
NOTE: If your vehicle is equipped with a rear camera or
RKE the electrical connector must be disconnected prior
to
Tri-Fold Tonneau Cover - If Equipped
Your vehicle may be equipped with a Tri-Fold Tonneau
Cover which consists of different features:
Easy Tri-Fold cover
Tonneau fore aft locator
Crosscar inside bed locator
Front and rear clamps
St
Tri-Fold Tonneau Cover Removal
To remove the Tonneau Cover follow the following steps:
1. Lower the tailgate to gain access to the first set of two
tonneau cover clamps located on the driver and passengers
bottom side of the tonnea
SEE MORE:
Snowplow
1500 Models Only
NOTE: Do not use this model vehicle for snowplow
applications.
WARNING!
Snowplows and other aftermarket equipment should
not be added to the front end of your vehicle. The
airbag crash sensors may be affected by the change in
the front end structure. The airbags could deploy
unexpec
Trailer Sway Control (TSC) - If Equipped
The TSC system uses sensors in the vehicle to recognize
an excessively swaying trailer and will take the appropriate
actions to attempt to stop the sway. The system
may reduce engine power and apply the brake of the
appropriate wheel(s) to counteract the sway of the trailer.
TSC will become active
© 2020-2026 Copyright www.ram-manuals.com
