Ram 1500/2500/3500 Owners & Service Manuals

Ram 1500/2500/3500: Uconnect Settings

The Uconnect system uses a combination of soft and hard keys located on the center of the instrument panel that allows you to access and change the customer programmable features.

READ NEXT:

 Hard-Keys

Hard-Keys are located below the Uconnect system in the center of the instrument panel. In addition, there is a Scroll/Enter control knob located on the right side of the Climate Controls in the center

 Soft-Keys

Soft-Keys are accessible on the Uconnect display. Customer Programmable Features - Uconnect 5.0/8.4 Settings Uconnect 5.0 - Press the SETTINGS hard-key to display the menu setting screen. Uconnect 8.4

 Soft-Keys - Display

After pressing the "Display" soft-key the following settings will be available. Display Mode When in this display you may select one of the auto display settings. To change Mode status, touch and r

SEE MORE:

 Jacking And Tire Changing 1500 Series Trucks

WARNING! Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull far enough off the road to avoid the danger of being hit when operating the jack or changing the wheel. Being under a jacked-up vehicle is dangerous. The vehicle could slip off the jack and fall

 Electronically Shifted Transfer Case (Five-Position Switch) (1) - If Equipped

This is an electronic shift transfer case and is operated by the 4WD Control Switch (Transfer Case Switch), which is located on the instrument panel. Transfer Case Switch (Five-Position) This electronically shifted transfer case provides five mode positions: Two-wheel drive high range (2WD) Four

© 2020-2023 Copyright www.ram-manuals.com