Ram 1500/2500/3500 Owners & Service Manuals

Ram 1500/2500/3500: Emergency Tow Hooks - If Equipped

Ram Truck 1500 2500 3500 (2009 - 2018) Owner's Manual / What To Do In Emergencies / Emergency Tow Hooks - If Equipped

Your vehicle may be equipped with emergency tow hooks.

NOTE: For off-road recovery, it is recommended to use both of the front tow hooks to minimize the risk of damage to the vehicle.

WARNING!

  • Do not use a chain for freeing a stuck vehicle.

    Chains may break, causing serious injury or death.

  • Stand clear of vehicles when pulling with tow hooks. Tow straps may become disengaged, causing serious injury.

CAUTION! Tow hooks are for emergency use only to rescue a vehicle stranded off-road. Do not use tow hooks for tow truck hookup or highway towing. You could damage your vehicle.

    READ NEXT:

     Shift Lever Override

    If a malfunction occurs and the shift lever cannot be moved out of the PARK position, you can use one of the following procedures to temporarily move the shift lever: Column Shifter - If Equipped 1. T

     Manual Park Release - 8 Speed Transmission

    WARNING! Always secure your vehicle by fully applying the parking brake, before activating the Manual Park Release. Activating the Manual Park Release will allow your vehicle to roll away if it is not

     Towing A Disabled Vehicle

    This section describes procedures for towing a disabled vehicle using a commercial wrecker service. If the transmission and drivetrain are operable, disabled vehicles may also be towed as described un

    SEE MORE:

     Power Inverter - If Equipped

    A 115 Volt (150 Watts Maximum) outlet is located on the center stack of the instrument panel, to the right of the radio. This outlet can power cellular phones, electronics and other low power devices requiring power up to 150 Watts. Certain high-end video games, such as Playstation3 and XBox360 will

     Programming A Non-Rolling Code

    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand - held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink button you wish to program. 3. Simultaneously press and hold both the HomeLink button you want to

    © 2020-2026 Copyright www.ram-manuals.com